Quantcast
Jump to content


Recommended Posts

Posted

Turns over great, has spark, shoots fuel, but it just won't start.. I've replaced starter, starter soliniod, battery and fuel injector.. I have no idea where to start now.. any help would be greatly appreciated. Thank you. 

  • Alex changed the title to 2016 Hisun sector 750 No Start
Posted

Try a simple test....the finger compression test.  Remove spark plug.  Put it back into cable and lay on clean as on no mud frame gnd....away from engine head.

Push finger/thumb over spark plug hole tightly.

Have helper crank over engine.

Good compression will blow your finger off with a nice POP!

Another clue.....everything is installed and crank over engine.  You should hear the motor cranking sound change....sorta like a Whop Whop Whop Whop.  This is the cranking speed dropping during the compression stroke starter loading then spinning faster during the other 3 phases of 4 stroke engines.  Chow

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Rainman
      I want to put a charger/maintainer for my Coleman UT400 for the winter and need to know if it uses a 6v or 12v battery.
      One search online showed a 6v, but another stated 12v..
      I can look at the battery, but after taking the seat out you cannot see the top of the battery without also removing the top plate under the seat and at 8 degrees outside, I'd rather not be out there too long.
      Can anyone verify what volt (6 or 12) the batter is?
      Thanks in advance ...
    • By Buddee
      2010 Hisun 500 - Carbed'.  She sat for about 3 weeks since last use.  Couldn't get it started.... has spark but plug was not wet.  Bought new plug, cleaned the carb, confirmed fuel pump (pulse type) is working.  Still nothing.  Put gas in the plug hole.... started right up and idled as normal and drove perfect.  Used it for the rest of the day without issue.  Tried to start again next morning.... same problem.  Poured gas in plug hole again.... started up and best kind again.
      Anyone have any insight to what's going on?
    • By JDawg
      Was using the machine all day to haul wood...no issues until the end...
      When I try to start it, the dash lights come on but starter does not...seems like no power to the starter.
      It is in park, but when I put the brake on to start, it registers N.
      Won't start in neutral either...
      Tried rocking it, did not help...
      Help...
    • By vachi
      hi everyone i have this 2021 Hisun forge 250 that won't start. no spark no fuel.   when i turn the key on i dont hear the relays click or fuel pump come on. it does have power but the relay doesnt ground the pump or the ignition coil. dont know if there are any safety switches on this model or not.  it does crank and all the accessories work. i  hot wired the pump and it does work.  i found a wiring diagram but it's very hard to figure out and was hoping someone has seen this before. all fuses are good. thanks in advance. 
    • eManualonline.com Save 30% OFF Sitewide, Use code: XMAS30
    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
×
×
  • Create New...