Quantcast
Jump to content


Recommended Posts

Posted

Hi, new member here, thanks for the ad. Our 2012 hisun hs 500 utv turns over but won't start unless primed. It'll run then for a few seconds & shut back down. It's just not getting fuel. Things we've done, installed brand new fuel pump, fuel pump relay, starter selonoid, replaced all the small fuses in fuse container...10-15 & 3 amps. Replaced a few Butt Connectors a 30 amp. Fuse for headlights. Tapped up some electrical wiring. Nothing has helped. It always started instantly. At a loss as to what to do next. Any suggestions would be so appreciated. TIA. Ann 

  • 1 month later...
Posted

I sure will. As of Saturday, the mechanic was looking into ordering a new wiring harness for the hisun hs 500. Said it'd save us money in the long run, rather than him chasing wires to find the issue. I'll update my post if we ever see it again,hits going on 6 weeks now😞

Posted

interesting i was having hell with mine with electrical issues finally found a gasket on the 18 pin connector into the fuse relay box was preventing the connector from  fully engaging causing a loss of ground though out the whole utv i pulled the gasket out lockwired the connector in place and it runs like a scalded dog now...i dont plan on running thru any water that high so....lol

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Jim Kessell
      2005 American Landmaster
      EH65 Subaru Robins
      spits fuel from breather hose into the air cleaner and then down into carb.  What’s causing this ??
    • By Ductking1
      I recently purchased a 2024 Hisun 550 Sector from Kreps Service Station and am having issues with the gear selector, I am doing as instructed in the owners manual but the shifter acts like it is binding or the button lock isn't releasing, the shifter will not move, I have to wiggle it back and forth while pushing hard on the brake and if it's in park or reverse it's nearly impossible to get it to move, I contacted Justin Krep and he says this is normal with these machines, I find that hard to believe, I've owned many utvs and side x sides and have never had this kind of issue with any of them, any help with this problem would be greatly appreciated.
    • By Nutcase
      I have a Joyner Trooper 1100 4 place that has been sitting for a number of years. I have everything taken care of but i can't get the fuel through the injectors. Fuel pump puts full pressure on them but they don't turn on or spray fuel. Any ideas?
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By hisun junk
      As I tried to do a conversion with the Yamaha 660 motor, I realized the 660 was never fuel injected so it would not work for the fuel injected hisun motor swap. But the good thing is the hisun 750 motor is a clone of the 660 Yamaha but with the components for the fuel injection (cam/crank position sensor). So that left me with a new rebuilt Yamaha 660 and still a broke 750 hisun motor. I took apart 750 think the timing chain had broke from all that I've heard about these motors. The chain was not broke, but just off cam and crank gears! The chain tensioner was at fault!  I've ordered Yamaha 660 replacement parts, chain, two exhaust valves (which got bent when chain came off while motor was spinning) and seals. The piston has 2 little nicks where it had hit valves but no damage otherwise. The head is being redone at the machine shop and I'll be putting it back together in the next couple of weeks. Also I finally tracked down a Service Manual with all the info on the 550/750 Challenger.

×
×
  • Create New...