Quantcast
Jump to content


Tracker 800SX LE Accesory Lights

Chaz Dean

By Chaz Dean
in TRACKER Off Road UTV SxS Forum

 Share

Recommended Posts

OviV Rookie

OviV

Posted
Posted

Are you using the switched or constant plug.  If you are using the switched plug (orange/black) you will not have power unless key is in the on position.

 

Ovi

Chaz Dean Newbie

Chaz Dean

Posted
  • Author
Posted

OviV,

Thnx for the response.

I've tried ALL Accesory plugs under the dash & Yes I understand that the key has to be On for it to work but with the key On I still can't get Power to the switches. 

I contacted my local BP & there tech informed me I had to take the dash Off & dig for the Red & Blk wires. 

Just Odd that there are 3 plugs under the dash & None of them have Power!  What's the Point!?

Chaz Dean Newbie

Chaz Dean

Posted
  • Author
Posted

Yes. There are no fuses or relay for the Accesories so I put a fuse in & pulled another relay & put it in the accesory block. Still Nothing. 

Also, on the wiring diagram it shows all of those plugs should have power.  

The Only plug that has keyed power is under the bed. Which I originally thought was for backup lights like on the Polaris Rangers. NOPE! Just power when the keys on. 

It's actually kind of Comical. 

OviV Rookie

OviV

Posted
Posted

I actually installed infrared camera on my 2021 800sx Crew and the 2 plugs behind the lcd  were as described in manual.  One constant and one switched.  

50716649-3D15-4437-B578-53D14D215EE6.png

  • 1 month later...
CarlF Newbie

CarlF

Posted
Posted

I am having the same problem I M an electrician of 35 years neither one of those plugs have power behind the dash the two wire ones doesn’t matter if the key is on off whatever none of the fuses are blown I tried to put other fuses in has anybody figured out what the problem is

Chaz Dean Newbie

Chaz Dean

Posted
  • Author
Posted

I found out on LEDs they have to be wired in correctly. Simply flipped our wires & everything is Good. 

Power on when the keys on. 

Solved our problem anyway. 

  • 7 months later...
dtscharner Newbie

dtscharner

Posted
Posted
On 9/24/2021 at 9:47 PM, Chaz Dean said:

What do I have to do to get Power to my Accesory light plug under the dash?

I've wired up a light bar & accesory pods & plugged into the accesory plug behind the center of the dash but No Power!!!

Help! Plz

Which light bar did you get? Would you mind posting a picture and letting me know how you like it?

  • 4 weeks later...
Greg In Iowa Newbie

Greg In Iowa

Posted
Posted

Hi Folks, I just bought a 2022 Tracker 800SX Crew. Love it so far. How do I access the accessory connectors behind the LCD display. Specifically, how do I pull out the display. Please offer any suggestions for anything I'm missing. I need to install a turn signal kit and eventually a winch. Thanks for any help. I've always found these boards helpful on other intersts of mine.

OviV Rookie

OviV

Posted
Posted
10 hours ago, Chaz Dean said:

I accesed it by lying in the floorboard & looking up behind the display in the console. 

Same here.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Topics

    • SouthernGypsy
      Help needed, Anyone recognize where this Internally Threaded Bolt belongs?
      By SouthernGypsy
      We have a 2018 Cub Cadet Challenger 400 and I found this Internally Threaded Bolt with a 10mm head size laying in the floor of the shop bay here on our ranch where we park the Cub Cadet.
      Trying to figure out where it belongs...
       




    • JOSEPH LAMAR
      Please help me solve this
      By JOSEPH LAMAR
      I have a 2020 axis 500 and I have replaced the TPS twice and the whole throttle body assembly once and still have code 122. I can barely drive the thing. It bucks and surges like crazy
    • A P
      2022 Hisun Sector 550 eps. Power steering not working
      By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • Texjpr
      Help! Hub safety-hour meter switch problem
      By Texjpr
      2002 ranger 500 4x4 stopped running and wouldn't restart. Service manual wiring diagram helped identify the hub safety switch as the culprit. Using jumper wires to bypass  switch allowed the engine to start and run normally. Inspection of switch showed melted epoxy and a strong smell of burnt electrical. Unable to find replacement part either used or new. Is there a work around other than jumper wiring?
    • Hunterman22
      2021 Hisun Axis 500 No Start - Need Help Please
      By Hunterman22
      2021 Hisun Axis 500 UTV (From Lowes)
      Will NOT START
      MY apologies if this is to much info just wanted to give yal the most information possible for help.
      I'm a so called diyer. An Electrician by trade 21yrs. I got my S×S from my last job. The contractor purchased this S×S for this specific job brand new, from Lowes. They used it for hauling materials, tools, & a little bit of anything you can think of on an Industrial type job site. 
      I remember getting on the SxS one time & pushed the gas petal all the way to the floor & SxS had very little power. 
      So anyway ,when the job finished up back mid July this year (7/2024) , I asked the contractor what they was going to do with it. I was told to take it. Otherwise it would go to the contractors yard (storage yard) & most likely rust away. 
      Took it home washed it , it had a heavy coat of dust on it & in it dust was every where. My helper & I had to push it on the trailer to get it home.  After washing it throughly I let it sit & dry out for a good day and half, maybe 2 days. Before trying to start it. NO START. Will turn over & try to start but thats it. 
      So here's what I've purchased & installed. New Air Filter, new spark plug, new air idle control valve (AICV), new throttle position sensor, new throttle body, new oxygen sensor, new digital dash speedometer/fuel gauge/clock. 
      Also drained the old oil & gas & replaced with new oil & 93oct. gas. I should probably mention that I've changed the AICV twice. The 1st time I changed the AICV I was able to get the SxS started & let idle for at least 10-15min. Drove out of the garage, with very little power,  turned it around & barely got it back in the garage.That was the one & only time I've been able to start the SxS. I've also cleaned the Throttle Body and & intake with TB cleaner.  So after that the AICV was  making weird noise so I pulled it out & tried cleaning it, pretty sure I messed it up. So I purchased a Throttle Body that came with new AICV & TPS. Still NO START.  I've checked the fuel pump & the fuel injector.  I took the injector off still hooked up to wiring & turned the key over, the injector sprayed a lot of gas out kinda the size of a volleyball. I've also checked the clearance gap on the intake & exhaust valve. But today 11/2/2024 I'm going recheck spark plug gap & the valve gaps. And alot of other checking. Would the driver side seat belt have anything to do with it not starting?? I know the driver side seat belt has to be in gauged for full throttle "going fast". Thing is the drv. side seat belt will latch but feels like might be messed up inside of it. Tired opening it up but to no avail.  I've never had a S×S or 4wheeler so I was really excited when I got the S×S,not so much anymore.  I work on & fix my own vehicles usually no problems.  But this SxS is kicking my ass.
      So if possible & someone could help me with some ideas or tell me what Im doing wrong or did wrong, I would greatly appreciate it.  Thank you for reading thus far.
       
       

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...