Quantcast
Jump to content


2009 Hisun HS700 UTV ---- I thought the problem was electrical but I just found this in the oil filler tube.


Recommended Posts

Posted

I thought the problem was electrical but I just found this in the oil filler tube. Does anyone recognize the part? I know I'll have to tear down the whole engine, and maybe I'll find the rest of it in there. Something beg enough to seize up the engine. That was the problem I was trying to diagnose.... 'Cause it's locked up. 

Thanks in advance.

Rick

 

20220102-121256.jpg

 

20220102-121514.jpg

 

 

  • Rick McGill changed the title to 2009 Hisun HS700 UTV ---- I thought the problem was electrical but I just found this in the oil filler tube.
Posted

Looks like a bearing cage to me. Maybe the crankshaft bearing. Not familiar with the engine. Either way, it has to be torn down if locked up.

Posted

OK. Thanks. That's what I've been hearing in another group.  I'm taking it to a guy who's done it before....  I'm hoping he can just replace the bearing and not the whole crankshaft. But I get it, impossible to tell until it's opened up.

 

Thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
    • By SouthernGypsy
      We have a 2018 Cub Cadet Challenger 400 and I found this Internally Threaded Bolt with a 10mm head size laying in the floor of the shop bay here on our ranch where we park the Cub Cadet.
      Trying to figure out where it belongs...
       




    • By se3388
      Hopefully someone else will buy a UT10X and join in.
       
      Steve.............
    • By Texjpr
      2002 ranger 500 4x4 stopped running and wouldn't restart. Service manual wiring diagram helped identify the hub safety switch as the culprit. Using jumper wires to bypass  switch allowed the engine to start and run normally. Inspection of switch showed melted epoxy and a strong smell of burnt electrical. Unable to find replacement part either used or new. Is there a work around other than jumper wiring?
    • By Reynolds Rocket
      I have a 2017 Intimidator XD4 800cc 4x4.  It will run great and then it's like it goes into safe mode and only runs on 1 cylinder.  It's not fouling out the plug when it happens.  Some times when I stop and restart it, it works fine.  First I thought it was a spark issue, then a fuel issue, but I feel like it's a short in the wiring some place. 
×
×
  • Create New...