Quantcast
Jump to content


Recommended Posts

Posted

I need some help.

 

I bought a new Renegade in June 2021 and have only put 60 miles on it and the other day checking cows I noticed the oil light on and the oil gauge reading zero and the oil light on.

 

Is there a better oil sensing unit than the factory?   I've ordered one from Joyner ($60) but would like to have a supply if they are going to go out after 60 miles. 

 

Thanks 

Posted

Was that oil light and pressure reading while idle?  Mine does that, too at idle.  The problem with Chery engines is that the oil pump barely has the volume needed at idle to maintain 10 psi per 1,000 rpms.  I put 50 weight oil in mine and it helps a little (15 psi at idle).  I bought a replacement on Amazon (VDO brand) because I thought I had the same issue.  No change.  But they are common on Amazon.  You might consider checking the oil pressure with an independent gauge (that's not made in China).

Posted

Dan,

It was hot when it went out.  I had changed oil from a 0w40 to a 10w30 (for the winter)  I have since changed oil again back to 10w40.  Still Little if any gauge response and the oil light is on.  The engine sounds fine and since it has a manual oil pump I'm not really too concerned still it's just the fact that it's practally brand new and this happened.  Only use it to check cows weekly.  Never been rained on.  No mud.  Never even had it in 4wd

 

Posted

The correct crossover part for the 1100 chery sending unit is VDO 360 025.  Better made part (made in  Germany) with a 24 month warranty.   Works both gauge and dummy light.   

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Topics

    • By Cory J
      Belt started slipping when I used it in high gear. It works okay in low unless I'm trying to power it up a hill and then it slips.., Ordered a new belt and went to change it and found a good bit of oil in the belt housing. Has anyone experienced this? Belt looks fine. Only have 300 miles on this thing..
    • By Frank in MI
      Thanks for accepting me!
      Haven't got a side by side yet, but have been shopping.   
      Any advice welcome & I am on a limited budget, so haven't decided yet on new or used.
       
    • By Poppateets
      I just purchased a used 2023 Massimo warrior UTV SxS 1000mx with 600 miles on it. I didn't even get a full day of riding and the driver's side rear axle broke. I'm pretty sure it was already going bad because we would hear a noise once in a while. I'm wondering if anyone else has had problems with theirs. Also looking for places to buy accessories.
    • By SouthernGypsy
      We have a 2018 Cub Cadet Challenger 400 and I found this Internally Threaded Bolt with a 10mm head size laying in the floor of the shop bay here on our ranch where we park the Cub Cadet.
      Trying to figure out where it belongs...
       




    • By JOSEPH LAMAR
      I have a 2020 axis 500 and I have replaced the TPS twice and the whole throttle body assembly once and still have code 122. I can barely drive the thing. It bucks and surges like crazy
×
×
  • Create New...