Quantcast
Jump to content


2017 Cub Cadet Challenger 750 won’t start

reignma_n

By reignma_n
in Cub Cadet UTV SxS Forum

 Share

Recommended Posts

reignma_n Newbie

reignma_n

Posted
Posted

Was driving the cub to work.  Cold out side so had it started for 15 min before I left.  Drove about 2 miles no problem then all of a sudden started to loose power, push gas to the floor to get off the side of the road.  Once turned off the road continued to put along so figured would get to a spot to be able to figure out.  Once I stop the engine died, and will just crank over and not fire.  Checked fuel filter no clog, has spark.  The oil was low but no light came on.  No sure if there is an oil kill switch or if the starting kill switch deal is malfunctioning.  Any help or ideas would be great.

 

Thanks

reignma_n Newbie

reignma_n

Posted
  • Author
Posted

Been below freezing.  When checking the filter it had a strong flow.  I was going to check the inlet to the intake.  But haven’t messed with that before so not sure what to look for.

T-boss 410 Experienced

T-boss 410

Posted
Posted

It just sounds like the fuel supply was restricted. I don't know if it's safe to use some dry gas, but I wouldn't think it would hurt, and it would get rid of any ice that possibly could be there. 

Does it have good spark?

reignma_n Newbie

reignma_n

Posted
  • Author
Posted

Yes the spark is strong.  I will mess with the fuel supply lines this weekend.   One thing I noticed is that it has the safety start deal where the brake has to be pushed in to start, even to crank it over, now it does it without the brake on, so thinking that may have something to do with it.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • CapnWalleye
      2016 Cub Cadet 500 runs rough
      By CapnWalleye
      Just picked up a Cub Cadet 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • CapnWalleye
      2016 Hisun 500 runs rough no power
      By CapnWalleye
      Just picked up a Hisun 500 that had shift issues (corroded fan gear) which I fixed. It also didn't seem to be running smoothly then all of a sudden it got worse. It seems to miss on both idle and when pushing the gas pedal to the floor and doesn't seem to be running at full power. I've been working with a local person who is walking me through some steps, but I'd like some input from this group as well. What I've done:
      - drained the fuel tank and replaced it with 93 octane fuel and added heet to help with any water problems.
      - replaced the fuel injector.
      - disconnected the battery (several times) to allow the module to reset.
      - set the valve clearance, both intake and exhaust, within specs ... intake was tight but exhaust seemed fine.
      - replaced the battery.
      - replaced the O2 sensor.
      Nothing has helped. Not sure what the next steps are, but would appreciate any expertise that can be offered here.
       
    • FTG-05
      Want a new work UTV; who and what should I look for?
      By FTG-05
      I want to ditch my Kubota RTV-XG850 and its moronic twitchy throttle design flaw, get rid of the problematic engine and the 40 mph purposely throttled speed.
      So far, I'm looking at the Honda Pioneer 1000 and the Polaris Ranger 1000, both of which have 1000-1500 lb payload bed capacity.
      What other makes and models should I be looking at?
       
      Thanks for the help!
    • A P
      2022 Hisun Sector 550 eps. Power steering not working
      By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • CRV
      Hello .. I have a 2007 cub cadet big country
      By CRV
      I’m need a couple parts. Diff. Lock Actuator mainly. But I would like to find a donor that maybe has bad motor or something along those lines. 
      if anyone has or knows of anything please holler at me 
      thanks Randy 

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...